"The people who design these airplanes don't work on them"

Metal in the filter, starting problems, and mechanics who don't understand the definition of installed are on tap this episode. Email [email protected] for a chance to be on the show. Join the world's largest aviation community at aopa.org/join Full episode notes below: Roger has a Mooney M20J that has developed an odd starting problem. Over the past few years he’s had to increase the time the boost pump runs before the engine will start, and even then it sometimes doesn’t fully catch. Paul suggested that the bellows inside the flow divider could be bad, which would cause it to perform poorly. Mike also suggested that the idle mixture could be set incorrectly as well. An rpm rise test can verify if it’s correct. Craig has a 182 that he uses to go back and forth to his fishing cabin. He took the back seat out and he wants to add in some plywood in the back to protect the structure. He isn’t planning to affix it in any way other than Velcro. His A&P told him to avoid doing this because the wood isn't burn certified. But without installing the plywood with a structural fastener, it’s not technically installed and he can carry it however he likes. Malcolm has an 182 with the Texas Skyways conversion, and it hangs up during the starting sequence. They’ve replaced the starter, bought a battery tender to check the battery, and more. It’s so obvious what the problem is, Mike says. This is a classic and common problem among Continentals. The starter drive adapter is bad, the hosts say. He can have the part repaired and it should no longer be a problem. Aaron found a significant amount of metal in the oil filter on his Piper Cherokee 140. There was aluminum in every pleat of his filter after only about 15 hours. They were thin, but large flakes. The pieces were too big to even show up in an analysis. No other metals were elevated in the analysis. Colleen suggests that it could be from the oil pump impeller, but since he only found oil in the filter, and not in the sump itself, he thinks it’s coming from the pistons. Mike said piston pins migrate back the other direction, which often means it’s self-resolving. As it turns out Aaron knew the answer. He removed all four cydlinders, and two of the piston pins were severely worn. They also found ring chatter. Mike said Superior has had issues with ring chatter and they’ve tracked down the manufacturing problem and replacing the cylinders under warranty.