technologyAug 25, 20221:16:10pending
Bambu VS Voron VS Prusa XL & Kicked out of the Studio?
About this episode
This episode starts with a short and frustrating story on why Tom might have to leave his new studio again. Next, Stefan and Tom talk about Corridor Crews YouTube channels once again, which recently was hacked. Stefan gives a quick insight into his new home automation setup that sends him notifications once a print is finished. Then there is a quick ramble about the "influencer playbook" that was published by a marketing agency that explains how to annoy influencers to promote a product with little to no pay. The question section covers the difference between sandpaper grids in Europe and the US, a quick comparison of the BambulabX1, a Voron 2.4, and the upcoming Prusa XL. Finally, Tom and Stefan answer whether small nozzles can be used for significantly wider extrusions and if they plan to build the upside-down Positron V3 printer.
Get every episode summarized
Each time The Meltzone publishes, we email you a written briefing from the transcript — the topics, who appeared, and any specific claims, with the ad reads skipped.
Email me new episodesFree for 3 shows. No card needed.
Hosts & guests
No transcript yet
This episode has not been transcribed. Request it and it moves to the front of the queue.
More episodes
