"My airplane is a flying experiment"

It's all engines all the time this episode. Rusty ones, sticky ones, and one that doesn't burn oil. Email [email protected] for a chance to be on the show. Join the world's largest aviation community at aopa.org/join Full episode notes below: Ralph had to throw away his relatively new engine. His flying club has a 1968 Cherokee 180. They overhauled their engine, and the first annual looked good. On the second annual and after only 100 hours of flying, they had a stuck valve. Digging in they found extensive corrosion. Now past a second overhaul, they want to ensure it doesn’t happen again. The hosts focus on how much (or little) the airplane flew with the new engine. 50 hours a year isn’t much, especially if they weren’t regular hours. An hour a week is great, for example, and something like 4 hours once a month is worse. They advise Ralph use camgard, fly more often, hangar it, and use an engine dehydrator.   Adam has a Cirrus SR20 on leaseback to a flight school with only 500 hours on it. A student was taking off, and around 900 feet they heard a bang, and experienced partial power and a loss of oil pressure. Lycoming took the engine back for an inspection. Sticking valves caused it to throw a rod. Mike said Lycomings often stick valves, and it’s something that should be expected. The manufacturer recommends a wobble test per Lycoming Service Bulletin 388C every 400 hours in airplanes and 300 hours in a helicopter. You can go a thousand hours with the new valve guides. Mike stressed that it’s also very important to be trained to detect morning sickness, which is usually the first sign of a valve sticking problem. If a cylinder doesn’t light up with the others on a cold start, or feel rough, it indicates valve sticking and the engine should be shut down right away and examined by a mechanic. Colleen suggests having an eagle eye on the engine monitor during the first startup of the morning. Mike said leaning aggressively, especially on the ground, can also help. Adam asks if Lycoming’s recommendation to run the engine up before shut down in order to clean the valves actually does so. Mike thinks it’s just inconsiderate of those around you, and maybe not terribly helpful.   Jason runs mogas on his Cessna 182. Last year he was climbing through about 8,000 feet and the engine started to stumble. He added carb heat and a few other things, but the engine seemed to come back to life on its own. His Savvy account manager said it was probably vapor lock. Mike agrees with the account manager that the airplane was exhibiting vapor lock symptoms. He thinks it’s possible that a fuel line might be close to the exhaust or something else is warming the fuel before it gets to the carb. Paul suspects it might be the fuel line to the JPI engine monitor transducer. They recommend wrapping it the fuel lines in fire sleeve to see if that improves the problem.   Thad has a 1977 Cessna 182Q. He had the engine rebuilt in 2021 and since then it has been “a rockstar.” He thinks it might burn too little oil. It’s only burning about a quart every 50 hours. It makes more chromium and aluminum than the lab is happy with. He wonders if the lack of fresh oil is somehow concentrating the contaminants. It’s possible he’s not getting enough lubrication on the cylinders, Mike said. The chromium can only come from the rings and the valve stems. Usually the problems with the valve stems come combined with increased nickel because they are made of an alloy. Mike said the aluminum in his report is ok, although slightly high. Thad said they’ve borescoped the cylinders and everything looks good. There’s still cross-hatching on the cylinder walls. The hosts are intrigued, but Mike thinks it’s faulty thinking. They debate how much metal stays in suspension though the process of adding quarts. Mike suggests keeping an eye on the filter, but otherwise to keep flying.